Making a little more progress with my engine rebuild, Just tightening the big stuff.
Now the crank primary gear is a 24mm A/F nut and the book says 36ft-lb
The problem is I can't find the torque setting for the clutch centre nut, this nut is 27mm A/F.
Anybody got any idea's ?
GT380 Clutch Nut.
Moderators: oldjapanesebikes, H2RICK, diamondj, Suzsmokeyallan
-
gt-keith
- On the main road
- Posts: 121
- Joined: Wed Dec 30, 2009 9:35 am
- Country: UK
- Suzuki 2-Strokes: GT380 & GSF650 Bandit
- Location: Wakefield, United Kingdom
-
oldjapanesebikes
- Moto GP
- Posts: 3229
- Joined: Sat Feb 07, 2009 12:43 am
- Country: Canada
- Suzuki 2-Strokes: GT750(Jx3,L,M,A,B),T500
- Location: Ontario
- Contact:
Re:
+1Barry S. wrote:Just use an impact wrench and put it on tight, I never torque them.
Ian
If at first you don't succeed, just get a bigger hammer !
If at first you don't succeed, just get a bigger hammer !
-
diamondj
- Road race school
- Posts: 785
- Joined: Tue Oct 14, 2008 11:00 pm
- Location: Wharton, NJ USA
Re: GT380 Clutch Nut.
The T500 clutch hub takes 36ft-lbs and I suspect the 380 should be about the same.
Jim
Jim
