TR750 Frame kit on ebay

Kris Bernstein · Post by **Kris Bernstein** » Tue May 26, 2009 7:40 am

http://cgi.ebay.co.uk/SUZUKI-xr11-20-tr ... |294%3A200

husson73 · Post by **husson73** » Thu May 28, 2009 8:28 am

Xpensive for a repro frame done by an unknow buider, no bid so

Kris Bernstein · Post by **Kris Bernstein** » Thu May 28, 2009 10:44 am

This is one of the Ragged Edge Frame Kits from the UK.
They built jigs from an original XR11 frame/swing arm and bronze welded (just like the factory frame), to original specification. I have seen these cromoly frames up close, along with their aluminum XR11 gas tanks and the workmanship is impeccable. Yes cost is high for a "repo" but find and original and let me know the cost of that??
Just putting things into perspective. I don't represent the bidder or Ragged Edge. Just know the kit and sadly cannot afford it either....

Kris

diamondj · Post by **diamondj** » Thu May 28, 2009 12:28 pm

I've bought fiberglass bodywork from Ragged Edge and can say they make nice stuff. I was tempted by the T500 squish head castings they had on ebay recently but I'm don't know where I'd get them machined after I got them!

Jim

tz375 · Post by **tz375** » Thu May 28, 2009 9:48 pm

Jim, there are a bunch of 2 smoke guys that could do the heads for you including John Aylor (Ja moo). I don't know if Zooke Eric can do them?

I'm sure Scott Clough could do them too. I can work out the shapes for you but you'd still have to get them machined.

Or try www.2strokeheads.com

TR750 Frame kit on ebay

TR750 Frame kit on ebay

Unknown Frame Bilder?