Buffalo head dilemma
Posted: Sun Jan 09, 2022 4:45 pm
I'd like opinions as to which of 2 modified heads I have available to go with. The 1st head has been milled and cc'ed. The thermostat housing (cavity?) has been shortened so much that IF a thermostat were to be used, it would fit down inside the bore and be held in position and pressed against the opening of the fitting directly below it. The combustion chambers of 2nd head appear to have been filled in with weld and re-machined to provide a conventional squish band area. The thermostat area hasn't been modified.
Thanks for any responses and opinions posted.
Thanks for any responses and opinions posted.