Suzuki 2 Strokes

Hi All,
Not been on here for a while mainly because everything is running smooth on my 1977 GT380. Anyhow I've just received a new Oil Tank Cap gasket set part number 44600-30832 as the plastic domed insert in my cap has fallen apart. The kit came with 3 parts, the rubber domed seal, the plastic domed insert and a flat plastic disc with 2 cut outs on the edge.
Does anyone know where the flat plastic disc goes as my original one does'nt have one and in what order are they fitted.
Kind Regards,
Glyn.

Hey Glyn,

I know this is an old post at this point, but I was reading through the Suzuki Service Bulletins looking for other information and may have saw the information you were looking for. Take a look at No. 13 of the General Bulletins and you'll see a diagram for seal installation on the oil tank caps. Looks to me like it goes cap-->plastic disc-->rubber seal-->plastic domed insert.

http://www.ozebook.com/compendium/techb ... 010-18.pdf



I've never had one of these apart so I can't be 100% sure if this is the right way, but I hope it helps you or someone else searching for this info.

Regards,

Jim

A new cap I bought never had a hole in it.