Gt 250 Float height measurement.
Posted: Fri Nov 27, 2020 6:46 am
Hi Guys....The carbs on my 73 250k are the individual float and pin type and all sources of info including Suzuki service data set the float height at 13.7mm. This is measured ( as far as I can ascertain ! ) from the casting top where the main jet screws in to what they call the tongue adjacent to the needle valve.
I’ve had to bend the tang ( which operates the valve directly ) a fair old bit to get this measurement! Now I’ve got running issues with idle and cold start up with a choke that doesn’t now seem to be working.
I’m now questioning whereabouts exactly along the float arm the measurement of 13.7 should be made. Hopefully someone can help if only to confirm or advise! Cheers
I’ve had to bend the tang ( which operates the valve directly ) a fair old bit to get this measurement! Now I’ve got running issues with idle and cold start up with a choke that doesn’t now seem to be working.
I’m now questioning whereabouts exactly along the float arm the measurement of 13.7 should be made. Hopefully someone can help if only to confirm or advise! Cheers