Pulling flywheel
Moderators: oldjapanesebikes, H2RICK, diamondj, Suzsmokeyallan
-
abotech
- Still in the Driveway
- Posts: 5
- Joined: Sat Oct 08, 2016 7:15 pm
- Country: United States
- Suzuki 2-Strokes: t500j gt500 76 t250 71
Pulling flywheel
I need to pull the flywheel off, sending crank to Peter for rebuild.What size bolt do i need to push flywheel off. It looks like 14mm x 1.5. Anyone have this info handy? t500
-
jabcb
- Moto GP
- Posts: 4241
- Joined: Mon Dec 13, 2010 4:32 pm
- Country: USA
- Suzuki 2-Strokes: 69 T350 thru 75 GT750
- Location: southwestern Pennsylvania
Re: Pulling flywheel
The rear axle works on some of the twins. Have not tried it on a T500, but it probably works.
BAS (Bike Acquisition Syndrome) - too many bikes but have room for more
Suzuki:
GT750 2x75
GT550 72 & 75
GT380 72
T500 69 project & 73 project
T350 69 & 71
Honda 85 CB650SC & 86 CB700SC
09 Triumph Bonneville SE
Suzuki:
GT750 2x75
GT550 72 & 75
GT380 72
T500 69 project & 73 project
T350 69 & 71
Honda 85 CB650SC & 86 CB700SC
09 Triumph Bonneville SE
-
abotech
- Still in the Driveway
- Posts: 5
- Joined: Sat Oct 08, 2016 7:15 pm
- Country: United States
- Suzuki 2-Strokes: t500j gt500 76 t250 71
Re: Pulling flywheel
I did a little measuring & looking. The flywheel is M16 x 1.5. KD tools sells a hardened pusher bolt. Its been ordered.
