1975 T500 rebore now won’t run
Posted: Wed Dec 01, 2021 1:42 pm
Have a1975 T500 that i have restored. Original engine was very noisey do to worn pistons and cylinder. So did a rebore and fitted Wiseco piston and rings. Now won’t run. If i use starter fluid can get it to run for maybe 10 seconds. Otherwise just fires a few times.
Have double checked carbs, points and timing but still will not run. Have tried kicking for a few days.
Temps in 40s and 50s. A 1970 i have fully restored starts fine just need the choke to get going. Have tried choking it.
I’m frustrated, any suggestions?
Thanks
Have double checked carbs, points and timing but still will not run. Have tried kicking for a few days.
Temps in 40s and 50s. A 1970 i have fully restored starts fine just need the choke to get going. Have tried choking it.
I’m frustrated, any suggestions?
Thanks