Page 1 of 1
cylinder head removal
Posted: Sun Nov 24, 2019 12:49 pm
by kawonda750
Hi. I am in Ontario Canada and working on my 3rd GT750. This is my latest winter project to keep me busy when I retire in a couple weeks. I have all the head bolts out but the head will not budge. Is there a hidden bolt or one from underneath ? This is a 76 GT750 A that has been sitting for quite a long while but in very nice original shape. I have tried the rubber hammer and even prying it with no decent result. Thanks
Dave
Re: cylinder head removal
Posted: Sun Nov 24, 2019 8:24 pm
by Cliff56
No hidden bolts!
Cliff in Whitby!
Re: cylinder head removal
Posted: Sun Nov 24, 2019 8:29 pm
by Cliff56
Nothing hidden on the underside!
Re: cylinder head removal
Posted: Mon Nov 25, 2019 5:36 am
by kawonda750
Thanks for the pics. It seems that the stud in the centre 3 vertical rows from the left is too big. I assume it was put in after. It is too big and the head will not slide over it. I think that I will have to drill it out.
Re: cylinder head removal
Posted: Mon Nov 25, 2019 5:39 pm
by Cliff56
10 mm studs shouldn't be through the head!
Re: cylinder head removal
Posted: Mon Nov 25, 2019 6:04 pm
by Cliff56
Studs are 4 inches long.
Re: cylinder head removal
Posted: Mon Nov 25, 2019 6:15 pm
by Cliff56
Block is 5 inches high.
Re: cylinder head removal
Posted: Thu Nov 28, 2019 11:53 am
by kawonda750
If you look at the pic of the head sent by Cliff, the small hole to the left of the plug hole on the right had a nut on a stud. This will not go through the hole as I try to lift off the head. I am able to move the head slightly back and forth and the stud actually turns with it..