Recently I had a humbling experience when I changed the brake pads on the rear of my 2009 Honda ST1300. I spent several minutes removing the caliper and internal bolts then had a monster time getting the new pads and spring back into place while trying to bolt it all back together with the caliper still connected to the swingarm - way too many pieces and working from under a fender. I opened the factory manual that I've had since buying the bike 4 years ago to get the torque values only to see "Procedures". Had I read those first, all I had to do was pull 1 pin and those pads would have slid out of the end of the caliper. Replacement is a <1 minute task when done per the manual. This is one of those classic examples of knowing too much (or so I thought). Oddly, the green factory manual I have for the GT750's does not cover any frame or brake components repair.
Inputs appreciated! Thanks, Gordon
Some will remember this restoration/build about 5 years back -
