removing oil pump T350

Everything you want to know about oil but were "afraid to ask"!

Moderators: oldjapanesebikes, H2RICK, diamondj, Suzsmokeyallan

Post Reply
woertske
Around the block
Posts: 50
Joined: Thu Mar 21, 2013 10:13 am
Country: Netherlands
Suzuki 2-Strokes: Suzuki T350

removing oil pump T350

Post by woertske »

Does anybody know what I have to change when I remove the oil pump from my T350.
And.. is it possible :roll:
I now when I don't change anything some bearings will be gone in a few miles :oops:

I hope someone give me some advice.

Regards,...
User avatar
tz375
Moto GP
Posts: 6204
Joined: Mon Nov 03, 2008 10:47 am
Location: Illinois

Re: removing oil pump T350

Post by tz375 »

Do not remove it. There is no good reason to run without a pump. Pump is reliable and variable output where pre-mix is none of the above.

Just my perspective.
woertske
Around the block
Posts: 50
Joined: Thu Mar 21, 2013 10:13 am
Country: Netherlands
Suzuki 2-Strokes: Suzuki T350

Re: removing oil pump T350

Post by woertske »

OK tz375 :D thanks..

But I think.. There will be some members who dit it.
And I hope they will give me some advise :mrgreen:

Regards...
User avatar
tz375
Moto GP
Posts: 6204
Joined: Mon Nov 03, 2008 10:47 am
Location: Illinois

Re: removing oil pump T350

Post by tz375 »

I don't have a 350, but most Suzukis use oil slingers on the main bearing and the crank has to be stripped to remove and modify them.

The next issue is that most Suzukis do not have an oil passage in the crankcases to get the oil down to those main bearings. If your cases don't have those drillings, then you need to modify the crank and crankcases like an RD Yamaha.

And then you have to carry oil and a mixing jug with you at all times. If you are racing that's not a problem. Buy and Accu-Mix jug and get the right mixture every time. For the street there are no advantages and whole lot of PIA issues.

Check with the guys in the UK that race T20 and T250s. They know more about the early twins than I do.
woertske
Around the block
Posts: 50
Joined: Thu Mar 21, 2013 10:13 am
Country: Netherlands
Suzuki 2-Strokes: Suzuki T350

Re: removing oil pump T350

Post by woertske »

Many Thanks for your information.

I will try to contact these uk guys :mrgreen:

Regards,
woertske
Around the block
Posts: 50
Joined: Thu Mar 21, 2013 10:13 am
Country: Netherlands
Suzuki 2-Strokes: Suzuki T350

Re: removing oil pump T350

Post by woertske »

I have spoken with Adrian Baker about driving without oil pump.
He said this about it:

Hi there
Yes, you can run it on petroil mix without the oil pump. Modern oils help as they are so much better than that available in the 70s.
It will almost definitely be fine with no modifications, but if you have it apart it is worth drilling some holes to just behind the main bearings as I did as this will help.
I'm not sure if you have oil guide plates behind the main bearings on the crank as the T20 does, but if you do, and you are splitting the engine, remove these as well.

Adrian


I decided to use the oil pump.
Hopefully everything works!! :mrgreen:
Image
Post Reply