CNC machined custom inlet manifolds for T/GT 500

Getting your blazingly fast Suzuki powerplant to perform even better!

Moderators: oldjapanesebikes, H2RICK, diamondj, Suzsmokeyallan

Post Reply
Zunspec4
Expert racer
Posts: 1087
Joined: Tue Dec 16, 2008 11:37 am
Country: UK
Suzuki 2-Strokes: T500R, SV1000S, TS125, Seeley T500
Location: Trowbridge UK

CNC machined custom inlet manifolds for T/GT 500

Post by Zunspec4 »

Hi All,

I received these today from cuddly Pete O'dell (The Motorcycle Works, Peterborough ) Two pairs of custom CNC machined inlet manifolds for the T/GT 500. Made to accommodate new Mikuni VM carbs. They angle the carb upward by 15 degrees so the left hand float bowl does not foul the crankcase. Very nicely made and nominally for a 36mm carb but can be fettled to match a 38mm (I already use them on the 38mm engine). Hopefully not too much effort to adapt them for 34mm. Sleeve rubbers to match are readily available from Allens Performance.

Image

Cheers Geoff
User avatar
jabcb
Moto GP
Posts: 4240
Joined: Mon Dec 13, 2010 4:32 pm
Country: USA
Suzuki 2-Strokes: 69 T350 thru 75 GT750
Location: southwestern Pennsylvania

Re: CNC machined custom inlet manifolds for T/GT 500

Post by jabcb »

His website: h[url]ttp://www.themotorcycleworks.co.uk/index.php/about/[/url]
BAS (Bike Acquisition Syndrome) - too many bikes but have room for more

Suzuki:
GT750 2x75
GT550 72 & 75
GT380 72
T500 69 project & 73 project
T350 69 & 71
Honda 85 CB650SC & 86 CB700SC
09 Triumph Bonneville SE
Suspensionking
Around the block
Posts: 89
Joined: Fri Jan 01, 2016 7:21 am
Country: Switzerland
Suzuki 2-Strokes: T500 Suzuki, AJR Bultaco, Honda NS475

Re: CNC machined custom inlet manifolds for T/GT 500

Post by Suspensionking »

Hi Geoff,

They look very nice

cheers

Eamonn
Post Reply