Hi All,
I received these today from cuddly Pete O'dell (The Motorcycle Works, Peterborough ) Two pairs of custom CNC machined inlet manifolds for the T/GT 500. Made to accommodate new Mikuni VM carbs. They angle the carb upward by 15 degrees so the left hand float bowl does not foul the crankcase. Very nicely made and nominally for a 36mm carb but can be fettled to match a 38mm (I already use them on the 38mm engine). Hopefully not too much effort to adapt them for 34mm. Sleeve rubbers to match are readily available from Allens Performance.
Cheers Geoff
CNC machined custom inlet manifolds for T/GT 500
Moderators: oldjapanesebikes, H2RICK, diamondj, Suzsmokeyallan
-
- Expert racer
- Posts: 1087
- Joined: Tue Dec 16, 2008 11:37 am
- Country: UK
- Suzuki 2-Strokes: T500R, SV1000S, TS125, Seeley T500
- Location: Trowbridge UK
- jabcb
- Moto GP
- Posts: 4241
- Joined: Mon Dec 13, 2010 4:32 pm
- Country: USA
- Suzuki 2-Strokes: 69 T350 thru 75 GT750
- Location: southwestern Pennsylvania
Re: CNC machined custom inlet manifolds for T/GT 500
His website: h[url]ttp://www.themotorcycleworks.co.uk/index.php/about/[/url]
BAS (Bike Acquisition Syndrome) - too many bikes but have room for more
Suzuki:
GT750 2x75
GT550 72 & 75
GT380 72
T500 69 project & 73 project
T350 69 & 71
Honda 85 CB650SC & 86 CB700SC
09 Triumph Bonneville SE
Suzuki:
GT750 2x75
GT550 72 & 75
GT380 72
T500 69 project & 73 project
T350 69 & 71
Honda 85 CB650SC & 86 CB700SC
09 Triumph Bonneville SE
-
- Around the block
- Posts: 89
- Joined: Fri Jan 01, 2016 7:21 am
- Country: Switzerland
- Suzuki 2-Strokes: T500 Suzuki, AJR Bultaco, Honda NS475
Re: CNC machined custom inlet manifolds for T/GT 500
Hi Geoff,
They look very nice
cheers
Eamonn
They look very nice
cheers
Eamonn