CNC machined custom inlet manifolds for T/GT 500
Posted: Wed Nov 07, 2018 7:47 pm
Hi All,
I received these today from cuddly Pete O'dell (The Motorcycle Works, Peterborough ) Two pairs of custom CNC machined inlet manifolds for the T/GT 500. Made to accommodate new Mikuni VM carbs. They angle the carb upward by 15 degrees so the left hand float bowl does not foul the crankcase. Very nicely made and nominally for a 36mm carb but can be fettled to match a 38mm (I already use them on the 38mm engine). Hopefully not too much effort to adapt them for 34mm. Sleeve rubbers to match are readily available from Allens Performance.
Cheers Geoff
I received these today from cuddly Pete O'dell (The Motorcycle Works, Peterborough ) Two pairs of custom CNC machined inlet manifolds for the T/GT 500. Made to accommodate new Mikuni VM carbs. They angle the carb upward by 15 degrees so the left hand float bowl does not foul the crankcase. Very nicely made and nominally for a 36mm carb but can be fettled to match a 38mm (I already use them on the 38mm engine). Hopefully not too much effort to adapt them for 34mm. Sleeve rubbers to match are readily available from Allens Performance.
Cheers Geoff