Hydraulic clutch lever and slave on t500
Posted: Wed Nov 08, 2017 9:29 am
I'm looking to install a hydraulic clutch assembly on my 73 t500. I purchased an inexpensive assembly on eBay fit right in but not getting the ~3/4" travel. Only getting ~1/2". I now ordered a 2001 gsxr worm slave to see if it's geared better to give me that 3/4" travel. From what I can tell the actuator are is longer. So might be able to drill pull point closer to slave requiring less travel on my hydraulic slave cylinder? I was also trying to find travel info on the higher end clutch lever assemblies? Brembo, Magura etc...
Anyone have any knowledge would love to hear???
Anyone have any knowledge would love to hear???