Suzuki2Strokes.com

Sundial Moto Sports

Suzuki Two-Stroke Message Board
Suzuki2Strokes.com
It is currently Sun Dec 16, 2018 1:15 am

All times are UTC - 6 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: VM34 slide springs
PostPosted: Sun Jan 07, 2018 2:03 pm 
Offline
Around the block

Joined: Thu Dec 05, 2013 12:32 pm
Posts: 84
Country: Austria
Bikes owned: GT750
Hello, I have installed VM34 aftermarket carbs on my BIMOTA GT. I figure they require quite a ig hand on the throttle control ( I am using early GT cable splitter). Does anyone have recommendations and sources for lighter springs? If my theory is right, cutting the original springs does would make them harder (spring rate becomes stiffer with less windings if everything else remains the same)
Thanks for your inputs


Top
 Profile  
 
 Post subject: Re: VM34 slide springs
PostPosted: Mon Jan 08, 2018 8:46 am 
Offline
Novice racer

Joined: Tue Dec 16, 2008 11:37 am
Posts: 911
Location: Trowbridge UK
Country: UK
Bikes owned: T500R, SV1000S, TS125, Seeley T500
Hello Wolfgangh,

I too found the std. VM springs too heavy using a twin pull throttle set-up. I went back to Allens Performance the UK Mikuni agent who supplied the carbs and they were able to supply lighter springs. You should be able to do the same.

Cheers Geoff


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 22 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group
Sundial Moto Sports forum © by Eric F. Kalamaja
Suzuki2Strokes.com