I'm looking to install a hydraulic clutch assembly on my 73 t500. I purchased an inexpensive assembly on eBay fit right in but not getting the ~3/4" travel. Only getting ~1/2". I now ordered a 2001 gsxr worm slave to see if it's geared better to give me that 3/4" travel. From what I can tell the actuator are is longer. So might be able to drill pull point closer to slave requiring less travel on my hydraulic slave cylinder? I was also trying to find travel info on the higher end clutch lever assemblies? Brembo, Magura etc...
Anyone have any knowledge would love to hear???
Hydraulic clutch lever and slave on t500
Moderators: oldjapanesebikes, H2RICK, diamondj, Suzsmokeyallan
-
Suzuki tr500
- Still in the Driveway
- Posts: 3
- Joined: Sun Sep 17, 2017 11:21 am
- Country: United States
- Suzuki 2-Strokes: Gsxr 600, gsxr 740, gsxr 1000, t500
-
Alan H
- Moto GP
- Posts: 3249
- Joined: Thu Feb 16, 2012 11:50 am
- Country: England
- Suzuki 2-Strokes: 4 x GT550s - J, M, A, B.
- Location: The Republic of South Yorkshire
Re: Hydraulic clutch lever and slave on t500
Lots of knowledge on here, but who are you?
A hello and intro would be a polite start.
A hello and intro would be a polite start.
Think of how stupid the average person is, then realise that half of them are more stupid than that.
