Only vaguely connected to bikes but - (well it is a bike trailer!)
Re-wiring it.
I have sealed LED light units - tail, brake, indicator. The tiny 4-pin connector has no indication of which is the earth. So how to test?
I assume I need to use the Diode position on the meter? I'll do it by trial and error today, but I'm curious. Any ideas?
LED stop/tail/ind ID & test
Moderators: H2RICK, diamondj, Suzsmokeyallan, oldjapanesebikes
-
joolstacho
- To the on ramp
- Posts: 364
- Joined: Sun Jul 13, 2014 7:55 pm
- Country: Australia
- Suzuki 2-Strokes: AS50, GS500, GT500, ex GSXR750 slabbie
- Location: Greendale Vic, Australia
- Contact:
-
joolstacho
- To the on ramp
- Posts: 364
- Joined: Sun Jul 13, 2014 7:55 pm
- Country: Australia
- Suzuki 2-Strokes: AS50, GS500, GT500, ex GSXR750 slabbie
- Location: Greendale Vic, Australia
- Contact:
Re: LED stop/tail/ind ID & test
Well using the following (below) now I know WHITE is earth I was able to test using a battery:
Left indicator - yellow.
Right indicator - green.
Reverse - black.
Brakes - blue.
Stop lamps - red.
Earth return - white.
Rear lamps: clearance and side markers, brown.
Left indicator - yellow.
Right indicator - green.
Reverse - black.
Brakes - blue.
Stop lamps - red.
Earth return - white.
Rear lamps: clearance and side markers, brown.
