T500-III Mirror P/N's help needed
Posted: Mon Feb 23, 2009 10:49 am
delete
Page 1 of 1
Posted: Mon Feb 23, 2009 1:56 pm
Check a part number for the 10MM mirrors, see if they are the same.
Posted: Mon Feb 23, 2009 2:36 pm
delete
Posted: Mon Feb 23, 2009 2:43 pm
You can probably get new mirrors from Suzuki but they will not have the 'S' on them. I bought some new TS250 ones a year or two ago, no S.
Posted: Mon Feb 23, 2009 3:12 pm
delete
Posted: Mon Feb 23, 2009 4:24 pm
This whole thing is kinda weird.
My crossover book doesn't mention sizes but shows the R/H mirror for T500-II, -III and -R as 56500-19010 which was still a valid part number with no changeup as of 05/77.
56500-19600 is also a R/H mirror which fits a bunch of bikes.....but NOT any T500s at all.
That number changed up to -31010 and it NOW fits the T500J, K and L along with all the Triples from the same years. This part number was still current as of 05/77.
The 56500-31011 R/H mirror fits the GT500A and B along with the M/A/B Triples as well.
Somebody correct me here, but I thought all the Triples used 10mm stem/thread mirrors in all model years ??
My crossover book doesn't mention sizes but shows the R/H mirror for T500-II, -III and -R as 56500-19010 which was still a valid part number with no changeup as of 05/77.
56500-19600 is also a R/H mirror which fits a bunch of bikes.....but NOT any T500s at all.
That number changed up to -31010 and it NOW fits the T500J, K and L along with all the Triples from the same years. This part number was still current as of 05/77.
The 56500-31011 R/H mirror fits the GT500A and B along with the M/A/B Triples as well.
Somebody correct me here, but I thought all the Triples used 10mm stem/thread mirrors in all model years ??
Posted: Mon Feb 23, 2009 6:27 pm
It's about a 10 minute job to convert to 10mm. Just drill it out and re tap it. I had to do that on my GT750 as one of the mounts was 8mm and the other a 10mm. I reworked the 8 to a 10 and used a pair of 10mm mirrors.
Posted: Mon Feb 23, 2009 8:00 pm
Till 1974 they were 8 mm, then they switched to 10mm in 1975Somebody correct me here, but I thought all the Triples used 10mm stem/thread mirrors in all model years ??
Posted: Tue Feb 24, 2009 10:43 am
delete
Posted: Wed Feb 25, 2009 7:45 am
The 8mm mirrors are still available from the dealer i use and they are 8mms shaft units with no 's'.
The rubber mounts i won off of ebay were nice 8mm units too so i got the mirrors and rubber mounts after a little searching.
The rubber mounts i won off of ebay were nice 8mm units too so i got the mirrors and rubber mounts after a little searching.
Posted: Wed Feb 25, 2009 12:49 pm
Thank you Ian and Allan. My memory is sooooooo spotty these days...... 