Page 1 of 1

GT500 - Carb Connector Orientation

Posted: Fri Oct 04, 2024 3:59 am
by Tailchaser1960
Hi,

Forgot to take a picture/make notes when taking the carbs apart for cleaning! Which way does number 29 (see picture below) go? There's a cut-out in it; does this line up with the hole in the top of the slide or does it go the other way round and "block" the hole off?

Cheers,

Jeff
Capture.PNG

Re: GT500 - Carb Connector Orientation

Posted: Fri Oct 04, 2024 5:41 am
by badgereng
I’m no expert on these bikes but does the exploded view you’ve referenced give you a clue?
The throttle slide (25-26) in the image doesn’t show a cut away which would naturally be facing the rear wheel on your bike and part number 29 looks like it ‘handed’ with a slot facing the front wheel.
If I had no better info than this picture, that’s where I’d start.

Re: GT500 - Carb Connector Orientation

Posted: Fri Oct 04, 2024 6:10 pm
by karl pa
I installed mine covering the hole. Not sure if that is correct, but I would think it should be sealed somewhat.