GT380 Transmission reassemble
Moderators: oldjapanesebikes, H2RICK, diamondj, Suzsmokeyallan
-
sh03031
- Still in the Driveway
- Posts: 4
- Joined: Tue Dec 22, 2020 9:40 am
- Country: CA
- Suzuki 2-Strokes: 380GT
GT380 Transmission reassemble
Been working on a complete restoration of a 380GT. I installed the transmission yesterday and before I installed the top part of the crankcase it was switching fine between all 6 gears. I proceeded to install the top of the crank case and tried again and it wouldn't go past 2nd gear. What am I doing wrong with the seating of the transmission that would cause that?
-
dollydog
- Yeah Man, the Interstate
- Posts: 630
- Joined: Fri Aug 11, 2017 7:09 am
- Country: england
- Suzuki 2-Strokes: several gt250 ramairs
Re: GT380 Transmission reassemble
might be a daft question, but did you try turning the mainshaft while you were trying to change gear? 
cheers, dd.
cheers, dd.
GTS250 road registered. TS250 engine, Ramair frame.
GT250 big bang road registered. Both pistons fire the same time. USD forks.
GT285 road registered. Overbored - 58mm and TS125 +2 pistons fitted.
GT10 road registered. '65 T10 engine, GT250 frame.
GT250 big bang road registered. Both pistons fire the same time. USD forks.
GT285 road registered. Overbored - 58mm and TS125 +2 pistons fitted.
GT10 road registered. '65 T10 engine, GT250 frame.
-
sh03031
- Still in the Driveway
- Posts: 4
- Joined: Tue Dec 22, 2020 9:40 am
- Country: CA
- Suzuki 2-Strokes: 380GT
Re: GT380 Transmission reassemble
I did not. I suspect therein lies my problem?
