GT750 CV TO VM CONVERSION
Posted: Tue Oct 23, 2018 8:37 pm
Hi 'yall,
it's been a while...
I'm in the middle of converting my CV bike to VM carbs. so far everything is going as planned except the throttle housing... going from push pull to pull only the entire housing moves back. I've tightened the 2 screws on the housing as tight as possible and it still moves. Am I missing something? has anybody had this problem? do I need to wrap the bars with tape to get stronger clamping strength? Is there something in the earlier throttle housing that the later models don't have?
Any advice or info would be greatly appreciated.
Mario
it's been a while...
I'm in the middle of converting my CV bike to VM carbs. so far everything is going as planned except the throttle housing... going from push pull to pull only the entire housing moves back. I've tightened the 2 screws on the housing as tight as possible and it still moves. Am I missing something? has anybody had this problem? do I need to wrap the bars with tape to get stronger clamping strength? Is there something in the earlier throttle housing that the later models don't have?
Any advice or info would be greatly appreciated.
Mario