Carb set up
Posted: Sat May 12, 2018 3:09 pm
Hello
I'm putting the carbs together on my 71 T250r and I assume the solid pin which attaches to the carburettor slide with the throttle cable is purely for the tick over it fits through the centre of a threaded nut and has a split pin in the top.
Any advice would be greatly received
Paul
I'm putting the carbs together on my 71 T250r and I assume the solid pin which attaches to the carburettor slide with the throttle cable is purely for the tick over it fits through the centre of a threaded nut and has a split pin in the top.
Any advice would be greatly received
Paul