OIL Pump T250

General discussion about Street two-stroke Suzuki motorcycles.

Moderators: oldjapanesebikes, H2RICK, diamondj, Suzsmokeyallan

Post Reply
Doss1961
On the street
Posts: 47
Joined: Mon Dec 11, 2017 3:19 pm
Country: United Kingdom
Suzuki 2-Strokes: T250 Hustler

OIL Pump T250

Post by Doss1961 »

Hello

I removed a plate from the end of the oil pump which is held on by 3 posi drive screws but it will not fit back flush there is a small tongue on the inside of the plate and I do not want to force it.

Has anyone had one apart before.

Thanks
Paul.
dollydog
Yeah Man, the Interstate
Posts: 630
Joined: Fri Aug 11, 2017 7:09 am
Country: england
Suzuki 2-Strokes: several gt250 ramairs

Re: OIL Pump T250

Post by dollydog »

easy :D
presume you have the oilpump off? anyway hold pump in left hand. triangular plate can only go on one way and that's the tab to the inside right [as you're looking at it]. press the plate on with left thumb and at the same time press the control arm [the one with the spring on it] back and forth with right thumb until the plate drops on flush. put screws back in and good to go. don't forget the 'o' ring though :D
cheers, dd.
GTS250 road registered. TS250 engine, Ramair frame.
GT250 big bang road registered. Both pistons fire the same time. USD forks.
GT285 road registered. Overbored - 58mm and TS125 +2 pistons fitted.
GT10 road registered. '65 T10 engine, GT250 frame.
dollydog
Yeah Man, the Interstate
Posts: 630
Joined: Fri Aug 11, 2017 7:09 am
Country: england
Suzuki 2-Strokes: several gt250 ramairs

Re: OIL Pump T250

Post by dollydog »

that's quite ok mate - anytime, just ask :D
cheers, dd.
GTS250 road registered. TS250 engine, Ramair frame.
GT250 big bang road registered. Both pistons fire the same time. USD forks.
GT285 road registered. Overbored - 58mm and TS125 +2 pistons fitted.
GT10 road registered. '65 T10 engine, GT250 frame.
Doss1961
On the street
Posts: 47
Joined: Mon Dec 11, 2017 3:19 pm
Country: United Kingdom
Suzuki 2-Strokes: T250 Hustler

Re: OIL Pump T250

Post by Doss1961 »

Hello DD
Took your advice and tried it tonight and it worked fine screws fitted and back to together just ordered a gasket then I will fit it

Thanks Paul
Post Reply