Page 1 of 1

OIL Pump T250

Posted: Wed Jan 24, 2018 2:14 pm
by Doss1961
Hello

I removed a plate from the end of the oil pump which is held on by 3 posi drive screws but it will not fit back flush there is a small tongue on the inside of the plate and I do not want to force it.

Has anyone had one apart before.

Thanks
Paul.

Re: OIL Pump T250

Posted: Thu Jan 25, 2018 5:43 am
by dollydog
easy :D
presume you have the oilpump off? anyway hold pump in left hand. triangular plate can only go on one way and that's the tab to the inside right [as you're looking at it]. press the plate on with left thumb and at the same time press the control arm [the one with the spring on it] back and forth with right thumb until the plate drops on flush. put screws back in and good to go. don't forget the 'o' ring though :D
cheers, dd.

Re: OIL Pump T250

Posted: Fri Jan 26, 2018 2:44 pm
by dollydog
that's quite ok mate - anytime, just ask :D
cheers, dd.

Re: OIL Pump T250

Posted: Sat Feb 03, 2018 6:22 pm
by Doss1961
Hello DD
Took your advice and tried it tonight and it worked fine screws fitted and back to together just ordered a gasket then I will fit it

Thanks Paul