Suzuki 2 Strokes

Hey guys

I hoped someone could help me out, I need some part numbers for an order and cant find my parts catalog.

I need number for;

- Gudgeon Pins.
- Gudgeon Pin circlips.
- Clutch pushrod oil seal.
- Oil seal for LHS crankshaft "plate" (it is a metal plate with 4 x countersunk screws which goes over the crankshaft. It has an oil seal which fits the crank)

Can anyone help me out?
Ive tried Alphaparts etc but their diagrams are unreadable (plus I cant even find the parts I want)

Cheers
Ash

Ash,

Try Temecula Motorsports for the fiche:

http://www.temeculamotorsports.com/fich ... &fveh=1932

And just in case that doesn't work:

PIN, PISTON
12151-04700

CIRCLIP
09381-12001

OIL SEAL
09285-06019

OIL SEAL LH HOUSING GASKET - DISCONTINUED
12335-20000

Looks like you're in luck for three out of four. At least the crank plate gasket looks like it wouldn't be hard to duplicate with some gasket paper. Do you still have the old one to serve as a pattern?

Jim

Thanks Jim, appreciate it.

That website seems to use the same diagram as all the others though, I cant read the numbers or even find the parts I want.

I also need to clutch pushrod seal, the diagram says number 27 (??) and the list only goes to 22...

Ash wrote:Thanks Jim, appreciate it.

That website seems to use the same diagram as all the others though, I cant read the numbers or even find the parts I want.

I also need to clutch pushrod seal, the diagram says number 27 (??) and the list only goes to 22...

Hey Ash,

I had posted the pushrod seal above:

OIL SEAL
09285-06019

I think that's the right part.... Without looking at a T125 engine - I *think* the clutch pushrod runs through the output gears, right? If so, that should be the part number you need.

Jim

Well, Ash, my T125 / T125II parts book 2nd edition printed April 1970 shows the following:

Piston pin = 12151-02000
Circlip = 09381-12001
Pushrod Oil Seal = 09285-05006
LH Crank Oil Seal HOUSING = 12331-20000 The pic shows the four holes in the flange and the next item on the list IS the 4 screws...so I'm assuming this is the item you referred to....but keep in mind it's the housing ONLY.

There is ALSO the conventional lip-type seal that fits on the LH end of the crank and this is listed as LH crankshaft oil seal = 09283-20011.
I can only assume that the seal is a press fit into the housing.

Also keep in mind that all numbers listed here MAY change up to newer numbers.....but these are all the original 1970 numbers as per my parts book.