Page 1 of 1
Kill Switch
Posted: Sat Sep 26, 2015 6:34 am
by grumpy56
Anyone with suggestions on how to install a kill switch on my 1970 T350? Thanks.
Re: Kill Switch
Posted: Sat Sep 26, 2015 7:56 am
by jabcb
Take a look at how the kill switch is wired up on a GT250.
The orange wire is the hot wire running from the ignition switch to the loads.
The coil orange wires connect to that orange hot wire.
Wire up the kill switch so that it connects to
1) the orange hot wire
2) the two coil orange wires
Re: Kill Switch
Posted: Sun Sep 27, 2015 5:36 am
by grumpy56
Appreciate the info. Thank you. BTW, where in SW PA are you from? I was born near Johnstown and went to school at PSU in Uniontown. Many moons ago on both!!! Used my GT380 as my commuter for several years there.
Re: Kill Switch
Posted: Sun Sep 27, 2015 7:03 am
by jabcb
grumpy56 wrote:Appreciate the info. Thank you. BTW, where in SW PA are you from? I was born near Johnstown and went to school at PSU in Uniontown. Many moons ago on both!!! Used my GT380 as my commuter for several years there.
Am east of Pittsburgh.
My first new bike was a black 1976 GT380.
Should have never sold it.
Re: Kill Switch
Posted: Wed Sep 30, 2015 6:44 am
by grumpy56
My GT380 was a red 1972. Had lots of bikes through the years, but that one was special. Rode it everywhere. Daytona twice, southern Illinois, no trip was too far. Comfortable and reliable (at least that's the way I remember it). Going to have to acquire another one one of these days.