Posted: Sat Jan 10, 2009 2:20 pm
What i did was:
- Swingarm was machined to make it fir
- Aluminum bearing spacer was narrowed to suit
- GSXR spindle was cut to fit the same width as the swingarm
- two spacer tubes were machined to fit over the GT spindle and inside the GSXR spindle (now just a spacer)
- The GSXR needle rollers and inner sleeves then all fitted
The problem is that the Gt spindle is so small and there are so many "spacers" i suspect it won't exactly handle like it's on rails.
I'm thinking of reaming out the frame to take a larger diameter spindle and then eliminate a couple of the spacers.
- Swingarm was machined to make it fir
- Aluminum bearing spacer was narrowed to suit
- GSXR spindle was cut to fit the same width as the swingarm
- two spacer tubes were machined to fit over the GT spindle and inside the GSXR spindle (now just a spacer)
- The GSXR needle rollers and inner sleeves then all fitted
The problem is that the Gt spindle is so small and there are so many "spacers" i suspect it won't exactly handle like it's on rails.
I'm thinking of reaming out the frame to take a larger diameter spindle and then eliminate a couple of the spacers.