engine casings S bolts + head bolts & nuts

[GT500Andy]

Perhaps it’s been asked before but unable to find it with the "search" was the engine casings S bolts + head bolts & nuts galvanized or nickel plated? Want to get the old rusty one redone but there to far gone to see what it was!

Andy

[gt-keith]

Hi,
I'm in the process of rebuilding GT380 motor, and just had the bolts bright zinc plated. They are definately 'S' bolts, so would think they are on the 500.

[GT500Andy]

Hi do you have some photos of the bolts?
Andy

[gt-keith]

Hi, yes but I'm a newbie on here and don't know how to upload photo's.

[oldjapanesebikes]

Displaying photos here is not straightforward - you have to host the photos elsewhere and then link to them from here - many folks in the US use Photobucket, but there are lots of options. There was a thread on this forum (I forget where exactly) that covered this. Basically once you have the photos hosted, then you insert a link into the post - the format is:

[img]http://the%20link%20to%20the%20file%20name[/img]

For example - if you right click on the image below you can see the link info by checking 'Properties' - and you just add the 'img' front and back ends as required.

[gt-keith]

Thanks Ian, a job for my daughter I think.

[gt-keith]

Hi Andy,

Bare with me on this, hopefully you should see a photo of my GT380 crankcases, mid rebuild with replated bright zinc 'S' bolts.

[oldjapanesebikes]

Thanks Ian, a job for my daughter I think.

Looks like you got it sorted !

[gt-keith]

Yep! up and running,

Thanks for the advice.

Keith.

[Zunspec4]

Hi Andy,

Not a very good photo but I had mine zinc plated with the "bronze" type finish.



Cheers Zunspec