Sorry folks - yet another question! I have the VM28SS carb off an mostly apart. Does teh needle jet/emulsion tube come out through the venturi?
this is usual on teh CV carbs on my Yams.. Ta.
VM28ss strip..
Moderators: oldjapanesebikes, H2RICK, diamondj, Suzsmokeyallan
-
daxman
- To the on ramp
- Posts: 349
- Joined: Thu Nov 07, 2013 1:59 pm
- Country: United Kingdom
- Suzuki 2-Strokes: A100 GT250 & 4t Yams!
- Location: Brussel County, England
-
sportston
- Expert racer
- Posts: 1155
- Joined: Wed Jul 10, 2013 12:04 pm
- Country: England, UK
- Suzuki 2-Strokes: FZ50, GP100, RG125 Gamma, GT380, Bandit 1200S
Re: VM28ss strip..
Yes. Remove slider, turn carb upside down, remove main jet and washer then drift it out with a suitable size drift. Easy-peasy. Don't forget to refit brass locating pin upon reassembly.daxman wrote:Sorry folks - yet another question! I have the VM28SS carb off an mostly apart. Does teh needle jet/emulsion tube come out through the venturi?
this is usual on teh CV carbs on my Yams.. Ta.
-
daxman
- To the on ramp
- Posts: 349
- Joined: Thu Nov 07, 2013 1:59 pm
- Country: United Kingdom
- Suzuki 2-Strokes: A100 GT250 & 4t Yams!
- Location: Brussel County, England
Re: VM28ss strip..
Great - thanks!
-
daxman
- To the on ramp
- Posts: 349
- Joined: Thu Nov 07, 2013 1:59 pm
- Country: United Kingdom
- Suzuki 2-Strokes: A100 GT250 & 4t Yams!
- Location: Brussel County, England
Re: VM28ss strip..
Update - cleared the gunge out of the bowls and the passageways so now reasonably happy with the cleanliness of these old carbs.
But on checking Haynes the main (idle?) screw says it should be 1.5 turns out mine were both closer to 5 turns out. Pilot air screws were both 'correct' at approx 1.25 turns out - any thoughts?
But on checking Haynes the main (idle?) screw says it should be 1.5 turns out mine were both closer to 5 turns out. Pilot air screws were both 'correct' at approx 1.25 turns out - any thoughts?
