Sundial Moto Sports
http://www.suzuki2strokes.com/forum/

NOS centre bearing and outside
http://www.suzuki2strokes.com/forum/viewtopic.php?f=18&t=13063
Page 1 of 1

Author:  ro55o [ Mon Aug 14, 2017 2:06 pm ]
Post subject:  NOS centre bearing and outside

Just seen these over there in USA, presume there real??
http://www.ebay.co.uk/itm/NOS-OEM-Suzuk ... SwfDhZgzu-

Might be of use to someone, too expensive to import.

Author:  Alan H [ Tue Aug 15, 2017 1:09 am ]
Post subject:  Re: NOS centre bearing and outside

Plenty of places in the UK doing crank rebuilds cheaper.

Author:  sportston [ Sun Aug 27, 2017 1:44 pm ]
Post subject:  Re: NOS centre bearing and outside

Crikey thats a lot of wedge for one bearing!

Author:  Zunspec4 [ Sun Aug 27, 2017 2:23 pm ]
Post subject:  Re: NOS centre bearing and outside

sportston wrote:
Crikey thats a lot of wedge for one bearing!


As a genuine Suzuki bearing that IMHO is a good price. I would rather have that in my engine than a say a Crusing image repro. I have been pestering the Suzuki Vintage Parts guys for the parts needed for re-building T/GT 500 cranks. They say they are considering it so get on their case too and who knows.

Cheers Geoff

Author:  johnakay [ Wed Feb 14, 2018 12:20 pm ]
Post subject:  Re: NOS centre bearing and outside

main crank bearings UK

https://www.ebay.co.uk/itm/SUZUKI-T500- ... SwZfNagtAe

Author:  sportston [ Sun Feb 18, 2018 11:22 am ]
Post subject:  Re: NOS centre bearing and outside

An interesting solution. I wonder how long it would last. I see they are a smaller bearing pressed into a shell. Only 7 balls instead of 8.

Author:  Zunspec4 [ Sun Feb 18, 2018 12:30 pm ]
Post subject:  Re: NOS centre bearing and outside

sportston wrote:
An interesting solution. I wonder how long it would last. I see they are a smaller bearing pressed into a shell. Only 7 balls instead of 8.

It is a a common method to get around the lack of availability of Suzuki OEM sized main bearings. My race rider, Gary May, had his own versions made for his race bike. An additional attraction is that to replace the inserted bearings was only £12 a pop. The main cost was getting the sleeves machined.

Cheers Geoff

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/