Sundial Moto Sports

Like i need another project .. but had to save her from the junk yard .

_________________
the older i get the faster i was

Had 5 of these.....87-98. Bloody loved them !
Would so love to have another.

_________________
Keeping old 2 strokes alive !

Its all yours $400 .. but it does have a bad engine

_________________
the older i get the faster i was

I never should have sold my slabside, especially since it was unmodified except for a loud ass Yosh pipe.

Mark

I'd be all over that if it wasn't for the Atlantic Ocean.

_________________
Keeping old 2 strokes alive !

Me too, superstrong engines and plenty of bits about. Only bike I had where I never got to the end of the acceleration in top gear (bottled out at 165 on the clock)

I threw down for a ebay engine http://www.ebay.com/itm/290836846336?it ... 60&vxp=mtr so i guess i am going to turn her into a runner . I started stripping her down to clean , paint and lube up bearings .

_________________
the older i get the faster i was

That bike is too new for you Dave!

_________________
No really... it's supposed to smoke.

1974 Suzuki Nomad 340
1975 Suzuki GT750 Waterbuffalo

True . i was already 33 when it came out but i like the fact that it has a aluminum frame and swingarm .. less parts to paint

_________________
the older i get the faster i was

_________________
the older i get the faster i was

Lots of 'improvements' to bikes since the era of GT's for sure. The lure of a newer bike is sometimes hard to resist. I figure when mine turns 50 it might be time to retire it to 'trailer queen' status and get a 2nd bike. I'll be 40 then, just in time for a midlife crisis purchase.

Looks like you're really making a lot of progress.

Josh

_________________
No really... it's supposed to smoke.

1974 Suzuki Nomad 340
1975 Suzuki GT750 Waterbuffalo

Now its a pile of clean(er) parts I found some bearings that needed replaced in the wheels and swingarm linkage .

_________________
the older i get the faster i was

Got in the new bearings and brake pads so pulled the frame and some of the parts inside where it was warm enough to work and started assembly .. greasing everything well as i went .

_________________
the older i get the faster i was

If you are thinking of putting newer GSXR suspension on that at some point, would you consider selling the 18 inch wheels and rotors/sprocket?
Did you get the engine with the bike, for the $400?....if so, that's a steal.....

This was my Ebay deal, with a leaking headgasket oil seal ....until i found out that I was given a title that was not valid....
Indiana is very uncooperative with any titlework...

_________________
MY TWO STROKE ADDICTION
coming soon....TZR250SP 3XV2...
RS 250 Cup bike
RGV VJ21 L
RGV VJ22 FL
RGV VJ22 N
RGV VJ23 T
RZ 350
GT 750 J....sold.....
GT 750 long term cafe project
SX-R 800
KD 80
JR 50
RZV 500 R

I have another set of same rims , rotors , forks but powder coated yellow at my house in Florida . I wasnt planing any changes to this one for now , i just want to get her up and running at the lowest cost which unfortunately is climbing as i pick up the must haves that included a replacement motor ( $850 ) so the 400$ bike is working its way to $1500 pretty quickly . I wish mine came with the stock paint job but it did come with a nice vintage Yosh pipe .

_________________
the older i get the faster i was