Any interest in these?
Posted: Wed Apr 27, 2011 5:33 pm
I am testing the waters. I can have these mass produced at a very reasonable cost. All 4 sizes for the triples as well as others. You are looking at a float height gage. It is produced from .080 aluminum flat stock. This is one that I had cut for my GT550. Takes all the guess work out of properly setting your float height. Simply drag it back and forth across your floats to get the setting spot on. The close up shot makes it look slightly distorted, but trust me it's not. May be as cheap as $5.00 if I have enough takers.
